User guide

on
-
16
D
-
4.5.2 Delete a Chase
1. Enter Program mode.
2. Press MEMORY button.
3. Hold down MEMORY button and then press a 1~12 button or press
PAGE to select a 13-24 button to delete a chase.
4.6 Clear Memory
1. Press the BLACKOUT/STAND ALONE for 3 seconds, into
Stand-Alone mode.
2. Hold down the MEMORY button and then press BLACKOUT /
STAND ALONE button, all memory will be deleted.
4.7 Light Show
1. Press LIGHT SHOW button. The LIGHT SHOW LED will light up,
indicating light show mode is active.
2. Press AUTO/SOUND/MIDI to activate Auto, Sound or MIDI mode.
The LEDs indicate which mode is activated.
3. Press the button ( 1 ~ 24 ) to run a desired lighting show.
on
-
5
D
-
2. To set the tilt position of the Scanners when programming
or to set the tilt movement range for Movement function
or to set DMX value 0~255 for channels of Shutter/Gobo/
Color/Rotation/Dimmer/Focus.
19. Speed ( Wait time )
Controls with two different functions:
1. To set chase speed ( wait time between scenes ) within
the range of 0.1 second to 5 minutes when running light
shows. The fade time of scenes will be always completed,
Speed slider decides the wait time ( interval time )
between scenes.
2. To set the pan position of the Scanners or to set pan
movement range for Movement function when
programming.
20. Fine
To control the pan or tilt movement of the fixture in the
smallest increments. Push down the joystick to active
Fine
function, push again to disable the function.
21. Override
To override the fixture/ fixtures when the show is running.
22. Button(1-24)
a.) Set DMX value 0~255 for channels of Shutter/Gobo/
Color/Rotation/Dimmer/Focus, or b.) save 24 memories
into the buttons.
23. Stand alone
2 extra easy controllers Incorporated for Master/Slave
immediate pre-programmed light shows.
24. Program Mode
Activate Program mode by pressing Blackout/Stand Alone
button. When the LED above the button is off, it’s in Program
mode.