User guide

6I
HID 150W Lamp Installation Or Replacement
• Always switch power off before installing or replacing the lamp. Never try to replace the
lamp when it is hot.
• Do not touch the bulb with bare hands. Cleaning the lamp with denatured alcohol and wipe
with a lint free cloth when lamp is dirty.
1. Loose the screw on the housing cover.
2. Loose the screws of the lamp wire from terminator
3. Remove the old lamp from the fixture.
4. Please be care to install the lamp into case, make sure it wedge tightly that it
can not move easily. WARNING: impropriety install will cause the lamp
lifespan shorten and maybe explosion during operation.
5. Connect the lamp wire to the terminator as before.
6. Please reinstall step 2 and step 1.
7I
4. How To Set The Unit
4.1 Control Panel
Display
To show the various menus and the selected functions.
LED
DMX On DMX input present
MASTER On Master Mode
SLAVE On Slave Mode
SOUND Flashing Sound activation
Button
MENU To select the programming functions
DOWN To go backward in the selected functions
UP To go forward in the selected functions
ENTER To confirm the selected functions
Remote controller input
By connect to the 1/4” microphone jack to control the unit for stand by, function and mode
Sensitivity
To adjust the sound sensitivity.
Microphone
To receive audio signal for sound activation.
DMX input/output
For DMX512 link, use 3-pin XLR plug cable to link the unit together.