User manual

zoopa 150
150150
150
www.acme-online.de
Charging of the helicopter
The helicopter gets charged by the charging
lead of the controller.
Switch OFF the helicopter and the
controller!
Connect the charging lead under the
coverage at the back side of the controller
with the socket marked “CHA” at the
helicopter. Now switch on the controller.
The procedure is displayed by the red LED
and is finished when the light turns green.
Charging takes about 30-40 minutes.
Please note that only full batteries can
charge the helicopter.
If charging is finalized earlier than
expected, the controller batteries are too
weak and need to be replaced! The
controller LEDs starts blinking when to
low to charge!
Preparation
Place the helicopter on a plain surface, so that the tail rotor points into your direction. Switch
on the helicopter. Check if any obstacles could affect fly. Step back for at least one meter and
then switch on the controller.
How to bind
The zoopa 150 ForceBack Turbo Helicopter has an auto binding function.
Flying
The range of the controller is about 60m.
Avoid flying directly under the ceiling or crashing against walls – this causes crashes and can
damage the helicopter. Optimal flight can be reached at around 1m height.
Turbo:
By pushing the Turbo button (right on the top of the controller) you can increase the speed.
The flight time is reduced then.
Trimming/Adjust
If the helicopter turns around its own shaft,
you can adjust this effect by turning the
trimming wheel.
You can also charge with an
USB-Cable: Art. No. AA0121