User's Guide

COMPANY CONFIDENTIAL
Wireless Field Programming Coil
Aclara Technologies, LLC
User Guide (DRAFT)
Rev. 1.3
Page 8 of 10
February 19
1 MTU Programmer Device
The following section describes the different steps for controlling and understanding the probe
programmer, as well as the behavior of the leds in different situations.
1.1 Turn ON the programmer
Turn on the programmer probe by pressing the button. The blue indicator will light. Wait until
blue indicator starts blinking slowly and release the button.
1.2 Turn OFF the programmer
In order to turn off the device, the user must press the button until blue indicator starts blinking
fast. At this moment, button must be released.
If user keeps pressing the button more than 3 seconds, the programmer will enter into
PAIRING mode and blue and red indicators will start blinking.
1.3 Pairing
In case the application shows an alert indicating to change to PAIRING mode, press the button
until red and blue indicators start blinking (more than 3 seconds). Release and try to connect
again to the programmer. Device remains on PAIRING state for 10 seconds until the application
is connected to it.