User's Guide

48 A c l a r a R F E l e c t r i c I - 2 1 0 + c U s e r G u i d e
Configuration Management
• The Aclara RF Network AMI system also supports 5, 15, 30, and 60 minute
averaging for voltage measurements. Other values are not supported by the
AMI system even though they may be supported by the meter.
• Seasons are not supported by the Aclara RF Network I-210+c. The AMI
system is expected to report readings every day. The MDMS database may
be mined to obtain seasonal data.
• The Rolling Status feature of the I-210+c is not directly supported by the
Aclara RF I-210+c. Instead, all supported alarms (as described in Supported
Quality Codes on page 38) will be reported to the MDMS. AclaraONE may
be used to view the history of the most recent cautions and errors which have
been reported by the meter.
• Remote Connect / Disconnect on page 24 describes a few remote disconnect
commands that are not supported over the air.
• The ability to remotely place the meter in test mode is not supported.
Configuration Management
When an I-210+c meter is built at the factory and outfitted with an Aclara RF
Network endpoint, it will be configured according to the customizations identified
in the customer configuration worksheet(s). All the meters will be configured the
same way. If the needs change, or if a service location has requirements that do not
fit the norm, it is possible to reconfigure the meter and/or endpoint to a new
configuration. These reconfigurations can be sent over the air.
The configuration management process assumes there are multiple stakeholders at
the utility, as represented in the following image.