User's Guide

A c l a r a R F E l e c t r i c I - 2 1 0 + c U s e r G u i d e 7
CHAPTER
3
R EGULATORY G UIDELINES
It is important that the installer follow all applicable national, regional, and local
codes. Failure to do so could result in an unsafe condition or injury. It may also
create a situation in which interference is created by the operation of the
equipment.
This manual will provide examples which are meant to be examples only. Local
and regional codes may require a different practice.
FCC/IC Compliance
NOTE This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
If receiving antenna needs to reoriented or relocated, it must be done by an
installer.
CAUTION Any changes or modification made to this device without the expressed,
written approval of Aclara Technologies LLC may void the user’s authority to
operate this device.