User Instructions

Final Assembly of SCG DCU
Document No.: AP-1X700-003-MAD Rev. D Page 7 of 12
Proprietary Document and Information of Aclara
Uncontrolled when printed unless marked ‘Controlled’ or ‘Production Copy’ with a date in red
4.2.8 On the top left edge of the enclosure are (2) slots for mounting the cover; see Figure 5-I.
Holding the cover as shown in Figure 5-II, place both tabs, on the covers edge, into the slots of
the enclosure. With the tabs in both slots, the cover should slide about ¼” toward the bottom of
the enclosure.
Close the enclosure cover and observe that the tab and slot mate up as shown in Figure 5-III.
Place the blade of a large screwdriver behind one of the cover tabs as shown in Figure 5-IV and
bend the tab to a 20-30
O
angle as shown in Figure 5-V.
Bend the second tab in the same manner.
Figure 5: Install Enclosure Cover
Enclosure Cover
I
II
III
IV
V