User Instructions

Final Assembly of SCG DCU
Document No.: AP-1X700-003-MAD Rev. D Page 4 of 12
Proprietary Document and Information of Aclara
Uncontrolled when printed unless marked ‘Controlled’ or ‘Production Copy’ with a date in red
4.0 Procedure:
4.1 Complete assembly of plastic box.
4.1.1 Install (10) barbed printed circuit board (PCB) retainers. These are manually pushed into the
holes provided in each PCB slide rail.
Install ALL (10) retainers in the position shown in Figure 2, even if there is no PCB installed.
4.1.2 Place clear plastic box cover p/n 056-9975 over the top of the plastic box.
Insure the (4) corner screws for the plastic cover are in place, but DO NOT tighten them down at
this time. They will be tightened by QA upon completing final inspection/audit.
Retainer
069-0080 (x10)
Figure 2: Install Barbed PCB Retainers
Detail