User Instructions

Final Assembly of SCG DCU
Document No.: AP-1X700-003-MAD Rev. D Page 11 of 12
Proprietary Document and Information of Aclara
Uncontrolled when printed unless marked ‘Controlled’ or ‘Production Copy’ with a date in red
4.3.3 Refer to Figure 9 for installation of the info label.
Clean the surface of the enclosure with Isopropyl Alcohol.
There is a unique info label for every model DCU. The Model# on the label must match the item
number on the work order. Refer to the current work order or assembly print to identify the label
part number.
Place the fixture in the orientation shown. Set the fixtures guide rail to the left edge of the
enclosure, then slide the fixture down until it stops against the enclosure mounting plate.
Remove the paper from the adhesive back of the label.
Holding the fixture firmly in place, use the reference edges of the fixture to position the info
label.
Insure the top/bottom edges appear parallel to the bottom edge of the enclosure.
Figure 9: Install Info Label
Info Label
FIX-1X700-001
Fixture