User Instructions

Final Assembly of SCG DCU
Document No.: AP-1X700-003-MAD Rev. D Page 10 of 12
Proprietary Document and Information of Aclara
Uncontrolled when printed unless marked ‘Controlled’ or ‘Production Copy’ with a date in red
4.3.2 Refer to Figure 8 for installation of
the Hazard label.
Clean the surface of the enclosure with
Isopropyl Alcohol.
Place the fixture in the orientation
shown. Set the fixtures guide rail to
the right edge of the enclosure cover,
then slide the fixture up until it stops
against the upper screw used to hold
the cover closed.
Remove the paper from the adhesive
back of the label.
Hold the fixture firmly in place and
use the reference edges of the fixture
to position the Hazard label.
Insure the top/bottom edges appear
perpendicular to the right edge of the
enclosure and free of wrinkles and
bubbles.
Figure 8: Install Hazard Label
091-11700-1
Hazard Label
FIX-1X700-001
Fixture