Technical Manual
Table Of Contents
- Table of Contents
- Product Specifications
- Warnings, Cautions, and Notes
- Introduction
- Commissioning
- Tools Required
- Connect to the Main Board
- Commission the DCU
- Installer Commands
- Global Commands
- Administrator Commands (for an LTE Backhaul)
- Alarm Menu
- Manufacturing Menu
- MTU Menu
- Transceiver Menu
- Records Menu
- Power Supply Debug Menu
- Transceiver Debug Menu
- Advanced Menu
- Global Navigation Satellite System (GNSS) Menu
- Maintenance
- Troubleshooting
- Testing the DCU
- Local Menu “WALL” Command Information
- DCU-Generated Headend Messages
- Index
Chapter C • DCU-Generated Headend Messages
D C U M a i n t e n a n c e a n d O p e r a t i o n M a n u a l 87
Transceiver T1HW=B On Reset Hardware Type of T-Board 1.
Transceiver T1SN=0001000aa6 On Reset Serial Number of T-Board 1.
Transceiver T2DISCONNECTED Event X
Synchronous serial channel 0 timeout; T-board 2
disconnected.
Transceiver T2FW=01.02.0014 On Reset X X
Firmware version loaded on T-Board 2. Format is
VV.RR.bbbb where VV is firmware version number. RR is
firmware revision number, and bbbb is build number.
Transceiver T2HW=B On Reset X X Hardware Type of T-Board 2.
Transceiver T2SN=0001000aa6 On Reset X X Serial Number of T-Board 2.
Transceiver T3DISCONNECTED Event X
Synchronous serial channel 0 timeout; T-Board 3
disconnected.
Transceiver T3FW=99.50.0020 On Reset X
Slot 3 T-Board Firmware Version identifier. Format is
VV.RR.bbbb where VV is firmware Version number. RR is
firmware revision number, and bbbb is build number.
Transceiver T3HW=B On Reset X Hardware type of T-Board 3.
Transceiver T3SN=00010156fb On Reset X Serial number of T-Board 3.
Transceiver TB_UNDETECTED Event X T-Board undetected. DCU is reset after this.
WiFi Board WFSW=6.6.0.0 On Reset WiFi version string.
Source Message Frequency DCU 2 DCU 2+
Mainboard
Firmware
Description