Technical Manual

Chapter C • DCU-Generated Headend Messages
D C U M a i n t e n a n c e a n d O p e r a t i o n M a n u a l 77
Cell Module CnktErr 34
Logged after
failed call
attempt
X 2.84
Cellular Always On Mode Interruption: Active call
aborted because Always on mode configuration changes.
Cell Module CnktErr 35 2.86
Cellular Module Busy Booting Linux OS: Module unable to
execute commands while booting.
Cell Module CnktErr 36 2.86
Generated when +CME ERROR: <err> is received in
response to an AT command. Last three characters "xxx"
denote the error code <err>. Available only when cell
verbose mode is enabled. Lookup codes in Telit User
Manual.
Cell Module CNUM=13143419089
Each call
attempt
X X
Message value indicates phone number of the cell phone
module.
Cell Module ConnectFail! X X Error generated after the 18th DCU call attempt fails.
Cell Module COPS= 310410
Each call
attempt
X
Roam settings for Wavecom Q2426BQM phone Message
value indicates the cell network that cell phone is
connected to at the time of the call. [The Messages are
sent with each call attempt]
Cell Module CPRL=1024
Each call
attempt
X
PRL (Preferred Roaming List) version information for
currently selected NAM (Number Assignment Module).
Message value indicates PRL (Preferred Roaming List)
version in a CDMA phone module.
Cell Module CSID=21
Each call
attempt
X
System Identification Number for CDMA phones.
0-32767: The mobile station is registered with the
system indicated; 99999: not registered
Cell Module CSWV=17.01.571
Each call
attempt
X X
Message value indicates firmware revision of cell phone
module. [These messages are sent following a reset and
with the transmission of test records from the DCU].
Cell Module IMEI1=35323806
Each call
attempt
X X First 8 characters of 15 character IMEI device identifier.
Cell Module IMEI2=4053332
Each call
attempt
X X Last 7 characters of 15 character IMEI device identifier.
Cell Module MEID1=35323806
Each call
attempt
X
First 8 characters of 14 characters of Mobile Equipment
Identifier (MEID) for GSM devices. MEID replaced CDMA
ESNs
Cell Module MEID2=405333
Each call
attempt
X
Last 6 characters of 14 characters of Mobile Equipment
Identifier (MEID)
Cell Module RSRP Reconnection X X 2.84
Reference Signal Received Power; only available when
cell verbose mode is enabled.
Cell Module RSRQ Reconnection X X 2.84
Reference Signal Received Quality; only available when
cell verbose mode is enabled.
Source Message Frequency DCU 2 DCU 2+
Mainboard
Firmware
Description