Technical Manual

Chapter C • DCU-Generated Headend Messages
D C U M a i n t e n a n c e a n d O p e r a t i o n M a n u a l 75
Cell Module CnktErr 7
Logged after
failed call
attempt
X X
Socket Error (Cannot Connect to Server) - Cannot
connect to TCP/IP DCU Server (a socket connection to
the machine had been accepted).
Cell Module CnktErr 8
Logged after
failed call
attempt
X X
Socket Error (Cannot Connect to Server) - Cannot
connect to TCP/IP DCU Server (a socket connection to
the machine had been accepted).
Cell Module CnktErr 9
Logged after
failed call
attempt
X X
Low Battery Error - Battery voltage has dropped
dangerously low during the data transfer and DCU has
entered a lower power standby mode.
Cell Module CnktErr 10
Logged after
failed call
attempt
X X
Cell Phone Reprogramming Failure - CDMA device Auto
Activate process failed.
Cell Module CnktErr 11
Logged after
failed call
attempt
X X
Cell Phone Reprogramming Success - CDMA device Auto
Activate process completed successfully.
Cell Module CnktErr 12
Logged after
failed call
attempt
X X Cellular Device Socket Connection Lost.
Cell Module CnktErr 13
Logged after
failed call
attempt
X X Cellular AT Command Sequence Failure.
Cell Module CnktErr 14
Logged after
failed call
attempt
X X No Data Carrier (Typical Modem Equivalent).
Cell Module CnktErr 15
Logged after
failed call
attempt
X X Busy (Typical Phone Equivalent).
Cell Module CnktErr 16
Logged after
failed call
attempt
X X No Answer (Typical Phone Equivalent).
Cell Module CnktErr 17
Logged after
failed call
attempt
X X Cellular device cannot establish socket connection.
Cell Module CnktErr 18
Logged after
failed call
attempt
X X
DNS Look-up Error: Failed to convert the connect
machine name into a valid IP Address. Connecting to
AcaraONE headend requires IP address format (rather
than Domain Name Server format).
Cell Module CnktErr 19
Logged after
failed call
attempt
X X Unknown Error - Contact Aclara.
Cell Module CnktErr 20
Logged after
failed call
attempt
X X
User Abort Error: Call was manually aborted by user
pressing CTRL+A.
Source Message Frequency DCU 2 DCU 2+
Mainboard
Firmware
Description