Technical Manual

Chapter B • Local Menu “WALL” Command Information
D C U M a i n t e n a n c e a n d O p e r a t i o n M a n u a l 67
Receiver02: 9975T Transceiver information for the card in slot 2.
MAC address:
00:1d:24:00:01:04:9a:6b
Assigned T-Board media access control address (MAC ID).
F/W Rev: 01.73.0003 Firmware revision of the board.
H/W Rev: B Hardware revision of the board.
Radio Temperature = 47.0C Die temperature of radio chip assigned to transmit.
Processor Temperature = 47.6C Die temperature of T-Board MK64FN1M0VLQ12 processor.
Power Supply Temperature =
46.8C
Power Supply Board chip temperature.
Power Amp Temperature =
44.2C
Radio Board Power Amplifier Temperature.
+12V monitor = 12.027V Power Supply Board output voltage provided to electronics.
Date/Time = 06/10/2020
15:12:20
Date and time on the transceiver boards. This should be the same the time on the
Mainboard located at the bottom of the 'w' or 'wall' command output.
456387500:RSSI=-122.0dB:-121.9dB,
456437500:RSSI=-123.0dB:-123.0dB,
456637500:RSSI=55.0dB:55.0dB,
457087500:RSSI=55.0dB:55.0dB,
457412500:RSSI=55.0dB:55.0dB,
457862500:RSSI=55.0dB:55.0dB,
457887500:RSSI=55.0dB:55.0dB,
467362500:RSSI=55.0dB:55.0dB
Provides the instantaneous background noise measurements for each programmed
channel.
Available Frequencies
456387500,456437500,
456637500,457087500,
457412500,457862500,
457887500,467362500,,,,,,,,,,,,,
,,,,,,,,,,,
Available Frequencies is a list of all licensed frequencies for a deployment. These
frequencies are programmed at manufacturing and are the superset of frequencies that
can be used for the Transmit and Receive frequencies.
Front End Gain= -10.0dB
Front End Gain is currently programmed during manufacturing value and is used in Aclara
RF devices to adjust the transceiver board’s reported RSSI values to compensate for the
gain of the front end modules.
Field Example Description