Technical Manual

62 D C U M a i n t e n a n c e a n d O p e r a t i o n M a n u a l
LTE Mode
APN: xxxxxxxxxx
Displays the APN configured the for the DCU. Check to ensure the appropriate APN is
used to avoid connectivity errors.
User/Pswd:
Displays the Username and Password associated with the APN; it is standard that these
are blank.
Main Backhaul: Cellular
Displayed in Failover Backhaul confgurations. Defines the Main/Primary Backhaul the
DCU will use to connect. This can be changed in the menu.
Ethernet/Fiber Backhaul IP1:
10.XX.X.XX, 23XXX
Defines the IP address and port for the Ethernet or Fiber connection. Ensure this
information matches the customer server requirements.
Ethernet/Fiber Backhaul IP2:
10.XX.X.XX, 23XXX
The second IP address can be used for a data recovery server in the event the primary
server is down. If a customer is only using a single server IP, the settings in the IP1 are to
be mirrored.
Cellular Backhaul IP1:
10.27.X.XX, 23XXX *
The IP addresses for the cellular connection typically route through a client VPN and are
different than the Ethernet/Fiber IP addresses. The secondary IP address should be the
same as the primary unless a data recovery server is in use. An * indicates the IP and Port
the DCU is actively connected to.
Cellular Backhaul IP2:
10.27.X.XX, 23XXX
DHCP ON
The cellular IP address may be dynamically generated by a network DHCP server or
statically set. To use a static IP address set DHCP=OFF, and set the IP address below. To
use dynamic IP address, set DHCP=ON and let DHCP server select your IP address below.
MyIP Address: 10.120.9.8
Defined by the network: 32-bit number assigned to each device consisting of network
address (10.120.9) and host address (8). This number is auto-generated with DHCP on.
When DCHP is off, this IP address will be entered based on customer networking
requirements.
MySubnet Mask: 255.255.255.0
Defined by the network, this is used to determine the bits used for the network address
and therefore allows you to separate the network address bits from the host bits.
MyGateway: 192.168.1.1
Defined by the network, this 32-bit number is assigned to a router (Default Gateway)
that is used to communicate with other networks. This number is auto-generated with
DHCP on. When DCHP is off, this IP address will be entered based on customer
networking requirements.
MyDNS Server1: 192.168.1.1
Defined by the network; this is the IP Address of a primary AclaraOne server. This
number is auto-generated with DHCP on. When DCHP is off, this IP address will be
entered based on customer networking requirements.
Field Example Description