Technical Manual

Chapter 4 • Commissioning
D C U M a i n t e n a n c e a n d O p e r a t i o n M a n u a l 25
Global Commands
In addition to the Installer Commands, you may also invoke any of the Global
Commands described in the following table. These commands are supported on
every screen.
22 Enable Roaming
Allows cell phone to connect if in
roaming status. Intended for test
purposes only. Defaulted to disabled;
not recommended for field use due to
increased cell phone charges.
23 Save Configuration
24 Always On Mode
25 Access Point Name
26 GPRS User Name
27 GPRS Password
28 Auxiliary Power
? Help
Command Description Notes
Command Description
E Erase all records
F Set/Display the receiver frequencies (Enter frequency values in Hz with
a comma separating each channel. E.g. 462300000, 467300000, etc.)
V Toggle on/off system wide verbose mode.
W Display the current DCU configuration
X Save the DCU configuration
Z Toggle on/off the cell/modem power
< Generate test DCU records for testing DCU to AclaraONE
communications.
> Force a DCU call with current settings
^ Toggle MTU message debug monitoring. This option displays records
received from the MTU.
RESET Perform a soft reset on the DCU. This reboots the DCU to the last saved
configuration.
GEN1 Forces Gen1 backwards compatibility Mode
GEN2 Forces Gen2 mode
CTRL+A Cancel active dialing sequence
CTRL+G Displays the global DCU commands menu
CTRL+U Prompts the user to enter the access rights pass phrase in order to
change the current access rights level.
CTRL+V Show last verbose message sent to debug window.
. Redisplay the current menu
.. Return to the root DCU menu