Product Info

DRAFT 8-1-2019 Technical Brief
A c l a r a R a d i o M o d u l e I m p l e m e n t a t i o n R e q u i r e m e n t s 6
the ARM voltage at a regulated 3.6 VDC. The test board was designed to operate
over a single cell lithium battery voltage range in order to perform testing in RF
chambers without the requirement of an AC to DC power supply and the
associated conducted noise that can accompany them.
The JTAG port is for programming the host microcontroller. This is done once
during the production phase of the device. Any future revisions of device firmware
will be programmed over the JTAG port. The reset switch resets the
microcontroller if there is a need to do so.
The RF Output of the ARM connects to a 50-ohm controlled impedance strip-line
trace that connects to the SMA type RF connector. The RF connector is used to
make conducted RF measurements during certification testing.
This information should be enough to assure a proper installation of the ARM into
any new Aclara end point device that requires 450 MHz to 470 MHz licensed
narrow band RF transmission.
Labeling
Labeling
Étiquetage
The ARM will have a label containing the
FCC ID number and the ISED ID number
positioned on the top of the module shield. A
label with the HVIN number will also be on
the shield.
Le module ARM portera une étiquette
contenant le numéro d’identification de la FCC
et le numéro d’identification de l’ISED dans le
haut du boîtier du module. Une étiquette
portant le numéro HVIN figurera également
sur le boîtier.
Any Aclara product which uses the module
as the TX/RX portion of the circuit will have
a label on the outside of the product which
states that the product:
Tout produit Aclara qui utilise le module
comme portion TX/RX du circuit portera en
surface une étiquette déclarant que le produit :
CONTAINS: FCC ID: LLB2017025
CONTIENT
: ID FCC
: LLB2017025
IC: 4546A
-
2017025
IC
:
4546A
-
2017025
The external label material will be the
equivalent of 3M #7871, 2 mil, UV stable
gloss polyester, with high strength solvent
acrylic adhesive.
Le matériau de l’étiquette extérieure sera
équivalent à 3M n
o
7871, 2 mil, polyester
lustré résistant aux UV avec adhésif acrylique
puissant à base de solvant.
A sample label that contains the above
information is shown below.
Un exemple d’étiquette contenant les
informations qui précèdent est inclus ci-
dessous.