Installation Instruction

3
Elster / AMCO Gas Meter MTU Installation Instructions
NOTE
No repair or maintenance of MTU is required. Defective MTU will be replaced.
NOTE
MTU may be wiped with damp cloth to prevent electrostatic charge hazard.
Tools Required
To connect the MTU to these meters, you will need the following tools and equipment:
#2 Phillips screwdriver
1/4" Slotted screwdriver
Torque-limiting screwdriver
Safety glasses
Remove Index and Baseplate
1. Remove the anti-tamper, safety, and security hardware from the screws attaching the index cover
and baseplate to the meter.
2. Remove the index cover and index by removing the two screws securing it to the meter. Discard the
screws.
NOTE: If any of the screws are broken, or break during removal, DO NOT install the MTU.