Installation Instruction
3
Sprague/Actaris Gas MTU Installation Instructions
Tools Required
To mount the MTU to these meters, you will need the following tools and equipment:
• Phillips screwdriver
• Slotted screwdriver
• Torque-limiting screwdriver
• 3/32” hex key wrench
• Safety glasses
Remove Index
1. Remove all anti-tamper, safety, and security hardware from the clear index cover.
2. Remove the existing clear index cover by removing the three screws securing it to the meter.
Discard the screws and the cover.
NOTE: If more than one screw is broken, DO NOT install the MTU.