Installation Instruction

4
Elster American Gas Meter MTU Installation Instructions
3. Remove the two OEM screws from the index.
4. Set the index aside, and discard the old screws.
NOTE: If either of the OEM screws break during removal of the index, the remaining portion of the
screw must not protrude from the face of the meter. DO NOT install the MTU if there are any
protruding screws.
Mount Index to MTU/Pulser
1. Visually inspect the front of the MTU assembly and ensure that the coupler is properly engaged
with the gear shaft and that the coupler contains the magnet.
NOTE: Gear and Coupler are pre-assembled in the MTU.