Installation Instruction

MTU Single Port Pulse Devices Installation Instructions

• If the MTU input cable must be extended, use an appropriate splice.

• If wire clearance holes are needed to route wire from the meter to the MTU, drill a ¼” hole using

an appropriate drill bit. The installer is responsible for the selection of an appropriate location for

any hole to be drilled.

2. Make the appropriate connections to the meter. Refer to the meter documentation, if necessary.

Putting the Device into Service

Program the MTU

Program the MTU using the STAR Programmer Software.

Remove the MTU

Taking out of service by following steps in reverse order.

MTU Label Example

OTE

Specific Conditions of use in hazardous locations indicated on label.

List of Standards

1. ANSI/ISA 12.12.01

2. CSA 22.2

OTE

Training can be provided by Aclara or Aclara can train and certify third party installers. Installers

may be anyone certified by Aclara.