User's Manual

Hardware Installation
Series 4000 Maintenance and Operations Manual 25
Hollow Wall
Follow this procedure to mount the MTU to a
hollow wall.
Special Tools
In addition to standard hand tools and safety
equipment, you will need the following tools to
mount the MTU to a hollow wall:
• Drill
• ½" Drill bit
• 0-10 ft-lb Torque-limiting wrench
Instructions
1) Determine the appropriate mounting
location for the MTU. Keep RF signal
propagation in mind when choosing the
location.
2) Position the MTU against the wall at the
desired location and mark locations for the
four bolt holes.
3) Drill holes at the four marked locations
with a ½" drill bit.
4) Insert the anchor end of one wall anchor
through one of the drilled holes.
5) Pull the anchor until it is tight against the
back side of the wall surface. Then slide the
cap forward until it is flush with the wall.
DRAFT