User's Manual

24 Series 4000 Maintenance and Operations Manual
Wall Mount
Solid Wall
Follow this procedure to mount the MTU to a
solid wall.
Special Tools
In addition to standard tools and safety
equipment, you will need the following tools to
mount the MTU to a solid wall:
• Drill
• ¼" Wedge drill bit
• 0-35 ft-lb Torque-limiting wrench
Instructions
1) Determine the appropriate mounting
location for the MTU. Keep RF signal
propagation in mind when choosing a
location.
2) Position the MTU against the wall at the
desired location and mark locations for the
four bolt holes.
3) Drill holes at the four marked locations
with a ¼" Wedge Bit.
4) Insert a wedge bolt through a flat washer
and one of the mounting holes on the MTU.
5) Thread the bolt partially into the
appropriate hole drilled in step 3.
6) Repeat steps 4 and 5 for the remaining
bolts.
7) Tighten all four wedge bolts to 27-33 ft-lb.
DRAFT