User's Manual

MTU Instruction
for Actaris/Sprague/Schlumberger Gas Meters
Step 7 – Next, position the MTU on the
meter. Rotate the coupler into position to
ensure that it engages correctly with the
wiggler on the gas meter.
Step 8 – Now, firmly hand tighten the
mounting screws to 12 to 15 in-lb. The
gasket should be compressed slightly.
Be careful not to over tighten the screws.
Excessive torque may damage the MTU
enclosure. Because of this, power tools
are not recommended for this procedure.
Step 9 - Replace any anti-tamper, safety,
or security hardware onto the plastic
cover as required.
Step 10 – Once Installation is complete,
program the MTU using the STAR
Programmer Software and your MTU
Programmer.
PRELIMINARY