User's Manual
Table Of Contents
- Table of Contents
- 471-2000.pdf
- 471-2001.pdf
- 471-2002.pdf
- 471-2003.pdf
- 471-2004.pdf
- 471-2005.pdf
- 471-2006.pdf
- 471-2007.pdf
- 471-2008.pdf
- 471-2009.pdf
- 471-2010.pdf
- 471-2011.pdf
- 471-2012.pdf
- 471-2013.pdf
- 471-2014.pdf
- 471-2015.pdf
- 471-2016.pdf
- 471-2017.pdf
- 471-2018.pdf
- 471-2019.pdf
- 471-2020.pdf
- 471-2021.pdf
- 471-2022.pdf
- 471-2023.pdf
- 471-2026.pdf
- 471-2027.pdf
- 471-2028.pdf
- 471-2029.pdf
- 471-2030.pdf
- 471-2031.pdf
- 471-2032.pdf
- 471-2033.pdf
- 471-2034.pdf
- 471-2035.pdf
- 471-2036.pdf
- 471-2037.pdf
- 471-2038.pdf
- 471-2040.pdf
- 471-2041.pdf
- 471-2042.pdf
- 471-2043.pdf
- 471-2044.pdf
- 471-2045.pdf
- 471-2046.pdf
- 471-2047.pdf
- 471-2051.pdf
- 471-2052.pdf
- 471-2053.pdf
- 471-2054.pdf
MTU Instruction
for American Meter Company Gas Meters
Step 5 – Check that the register is
properly engaged by rotating the coupler
on the back of the MTU and observing
the register dials.
Step 6 – Next, Insert the two ¼-20 x 1
5/8” machine screws through the holes on
the MTU as shown here.
Step 7– Turn the MTU over and place the
rubber gasket on the back of the MTU so
that it aligns over the two screws.
Step 8 – Next, place the adaptor plate on
the back of the MTU so that it aligns over
the two screws.
Step 9 – The cork gasket is normally pre-
applied to the adaptor plate. Ensure that
it is in position on the back of the adaptor
plate.
Step 10 – Next, position the MTU on the
meter. Tighten the two ¼-20 x 1 5/8”
mounting screws most of the way, and
then rotate the register dials slightly to
engage the wiggler on the gas meter.
The wiggler must engage with the rear
coupler on the MTU as shown in these
illustrations. (Coupler shown detached
from the MTU for illustration purposes
only.)
Half-foot Drive Quarter-foot Drive
Page 151