User's Manual

62 TWACS
®
-ORION
®
for UMT Products User Guide
EMTR-3 Diagnostic Indicators
EMTR-3 Diagnostic Indicators
The following table lists the error code number and error message text that the
HHTR displays when the specific error is encountered while communicating with
the EMTR-3.
Table 3.2 Error code descriptions and solutions
Error Description Solution
The following error codes are RF communication errors.
01 RF Error General error. Retry the command.
02 Service Not Supported Service is not supported. Retry the command.
04 Operation Not Possible RF error. Retry the command.
05 Inappropriate Action
Requested
RF error. Retry the command.
06 RF Device Busy RF error. Retry the command.
07 Data From Device Not
Ready
RF error. (Usually memory) Retry the command.
31 RF Device Sent NAK RF error Retry the command.
32 Can not acquire an RF Link RF error Retry the command.
33 Operation Timed Out Operation time expired without
success.
Retry the command.
The following error codes are internal HHTR-3 or user errors.
101 RFPIC sends a NAK The RFPIC isn't ready or doesn't
understand the command. The RF
PIC internal to the HHTR-3 has
failed.
Retry the command.
102 RFPIC is Busy! RFPIC is performing another
operation and is currently busy.
The RF PIC internal to the
HHTR-3 was in the middle of
another command.
Retry the command.
103 No response from RFPIC
on HHTR
The RFPIC isn't responding to the
UI. No Response from the RF
PIC. The RF PIC didn't respond
to the UI processor.
Retry the command.
104 RFPIC Sent Invalid
Response...
The RFPIC sent an invalid
response to the UI. The HHTR-3
UI processor didn't recognize the
response from the RF PIC.
Retry the command.
105 Operation Cancelled Indicates the Esc button was
pressed during an operation.
Continue to desired action.
221 Install Failed The HHTR was unable to install
the IED.
Retry the command
222 Removal Failed The HHTR was unable to remove
the IED.
Retry the command