User's Manual
Table Of Contents
- Table of Contents
- Figures and Tables
- 1 - Introduction
- 2 - Functional Description
- 3 - Troubleshooting
- 4 - Specifications
- Acronyms
- Glossary
- Index
34 Universal Metering Transponder for kV2c™ Meter User Guide
TWACS Installation
Changing the Sequence Delay
Normally it is not necessary to change the sequence delay. In the event that it is
necessary to change the sequence delay for one or more rate classes (because of
insufficient time between read commands to permit adequate transponder cooling),
the Altimus Command Configuration window is used.
Change the rate class sequence delay by following the instructions in the TNS
System Administration chapter of the TNS End User Guide.
See Meter Shop Test System on page 39 for more information on testing tools