User's Manual

DRAFT
TWACS
®
- ORION
®
for CENTRON
®
Meter User Guide 23
Installation and Operation
12. Press the Enter button to recheck. The EMTR-2 attempts to reacquire
the ORION signal. If the EMTR-2 is successful, the “success” screen
shown in step 9 displays.
13. Press the ESC button and the following two screens display.
14. Press the ESC button to return to the ORION Menu
Refer to Troubleshooting and Error Messages on page 28.
Delete the ORION from the Remt List
If your ORION and EMTR-2 are not communicating, or if you need to
replace a malfunctioning ORION module, this procedure provides the
instructions to delete the ORION from the Remt List stored in the EMTR-2.
Complete the following steps to delete the ORION from the EMTR-2.
1. Press the On/Off button on the HHTR-LP.
2. Press the down arrow button twice to position the cursor in front of
the EMTR option.
3. Press the Enter button.
Orion Install Menu
Warn: No Orion Data
EMTR S/N 123456
Orion S/N 123456
Orion Install Menu
Warn: No Orion Data
Reading: 0
RSSI: 0
Main Menu
Order
Serial Com
REMOTE
EMTR
TWACS
HHTR Config
Main Menu
Order
Serial Com
REMOTE
EMTR
TWACS
HHTR Config
EMTR Menu
Select
Status
Replace
Delete
Remt List