User's Manual

TWACS
®
- ORION
®
for CENTRON
®
Meter User Guide 27
Chapter 2 • Testing, Troubleshooting, and Maintenance
Remote Test Set (RTS)
Follow the procedures below to verify that the RTS can communicate to the
TWACS-ORION system.
W ARNING Installers must follow all utility electrical safety requirements before
connecting the RTS.
Consult applicable utility procedures when troubleshooting this
equipment.
1. Connect the RTS according to procedures outlined in the RTS User
Guide, Y10228TM.
2. Connect the RTS to an appropriate power source, 120VAC or
240VAC.
107 No Space Available in
EMTR. The Table is Full.
The EMTR is at capacity. It can
not accept additional Remotess.
A Remote must be
removed before adding
another.
112 EMTR already has
Remotes assigned
Can not program a new EMTR
with the data from an old EMTR
because the new EMTR already
has Remotes assigned.
Remove all Remotes from
the new EMTR first.
113 The New EMTR can not
accept xx Number of
Remotes.
Can not program a new EMTR
with the data from an old EMTR
because the new EMTR can not
store as many Remote as the old
EMTR.
114 An order needs to be
created first. Use the order
menu
When replacing an EMTR, the
HHTR needs to store the Remt
list. An “order number” needs to
be assigned so that the HHTR has
a location to store the list.
Select “order” from the
main menu, select “new”
and enter a number.
208 ORION S/N Already
exists in the EMTR Table.
Can not install the selected
ORION because it is already
installed.
209 The Selected ORION is
NOT in the EMTR Table.
Can not remove the ORION nor
perform a Com Status because
that ORION is not installed to the
selected EMTR.
Check serial number and
try again.
211 Service is Full, Can not
add ORION to the EMTR
List.
This service in the EMTR is at
capacity. It can not accept
additional Orions.
An ORION must be
removed from this service
before adding another.
215 The Selected Remt. is
NOT an Orion.
Table 0.1 Error Code Description and Solution
Error Description Solution