User's Manual

TWACS
®
- ORION
®
for CENTRON
®
Meter User Guide 13
Installation and Operation
ORION and EMTR Communication Setup
This section explains the steps required to use the HHTR to configure, link,
and remove/replace an ORION or EMTR.
RF equipment setup procedures consist of configuring the EMTR and making
the RF communication link between the ORION and EMTR. You may also
view the communication statistics, or test the link between the ORION and
EMTR by reading the Total Consumption register for the applicable port and
verifying the reading on the auxiliary meter dials.
Install the ORION (Linking the ORION and EMTR)
Complete the following steps to link the ORION to a nearby EMTR.
1. Press the On/Off button on the HHTR. The “flash” screen appears
momentarily displaying the software version number. Firmware
Vn.n
is replaced with the firmware version number installed in your
HHTR.
The Main Menu screen appears.
2. Press the down arrow once to position the arrow cursor in front of the
REMOTE option.
3. Press the Enter button.
4. Press the Enter button to accept the default selection.
DCSI: HHTR
Y72160-1
Www.twacs.com
Firmware Vn.n
Main Menu
Order
Serial Com
REMOTE
EMTR
TWACS
HHTR Config
Main Menu
Order
Serial Com
REMOTE
EMTR
TWACS
HHTR Config
Remote Menu
Select:
ORION
RMTR