User's Manual

HAN ZigBee™ Module 5
Chapter 1 • Specifications
The following is a tabulation of regulatory data found elsewhere in this manual and
is required by the regulatory agencies of some countries.
N OTE No subcarrier is used to modulate the carrier. Refer to paragraph 2, on page 1
for more information.
Table 1.6 HAN ZigBee Regulatory Data
Parameter Specification
Disclaimer noting that operation of the
device is subject to conditions and that the
device may not cause harmful interference
and device must accept any interference
received.
Regulatory Data note on page 1.
Principles of device operation HAN ZigBee Module on page 1
Block diagram Block diagram on page 2
Operating frequency 2400 - 2483.5 MHz,
Channeling 16 channels
Mode of transmission Narrow Band FSK
Internal/External data source External;
Type(s) of modulation OQPSK (
Offset quadrature phase-shift
keying);
Subcarrier modulation No.
Type of information transmitted Equipment control
Occupied bandwidth 2 MHz,
RF output power 100 mW, +20 dBm or less. Meets FCC
section 15.247 for field strength emissions
Carrier frequency stability Crystal controlled, ± 40 ppm or ± 98 kHz,