Audio Interface User’s Manual Eurorack Synthesizer Modules 14 HP
TABLE OF CONTENTS 1.INTRODUCTION 2.WARRANTY 3.INSTALLATION 4.FUNCTION OF PANEL COMPONENTS 5.SIGNALFLOW & ROUTING 6.
1. INTRODUCTION Audiophile Circuits League. -The main purpose of the ACL Audio Interface module is to interface modular synthesizer systems with professional audio recording and stage equipment. The combination of studio quality signal path, �lexible routing possibilities and a headphone ampli�ier, capable of driving both high and low impedance headphones with low distortion, makes the connection between these different environments effortless and sonically transparent.
2. WARRANTY Is it a malfunction? In the event of a fault in use, we will repair or replace it free of charge under the warranty terms stated below. The warranty period is valid for one year from the Please read the user's manual carefully and check again. If you think that there is day of purchase. If repair is necessary, please ask the dealer you purchased it still a problem, please consult the dealer you purchased from or contact us from. (English) .
3. INSTALLATION ⚠WARNING *Always turn the Eurorack unit off and unplug the power cord before pluging GATE the Eurorack power cable. CV *When attaching the Eurorack power cable, please be careful not to touch the +5V terminal part. +12V GND Connect to the Eurorack's system power supply (+ 12V) using the supplied GND Eurorack power cable. Connect the 16-pin connector to the Eurorack power connector.
4. FUNCTION OF PANEL COMPONENTS 8 7 14 ① "OUT LEVEL" knob 9 10 Output volume control for ③ "OUT" XLR sockets. ② "IN 1" "IN 2" jacks 13 3.5mm audio inputs (mono) for AC coupled unbalanced signals. Typically, you 1 4 will enter the modular �inal audio outputs into these jacks. These audio signals are converted to balanced signals and output from ③ "OUT" XLR sockets.
⑥ "IN" XLR sockets ~TIPS about headphone~ "OUT 1" "OUT 2" jacks. clipping. DC and clipping protection circuit for the headphone ampli�ier, switches off DC coupled electronically balanced audio signals are input from these XLR headphone output if DC at the output exceeds ±50 mV and/or in case of hard sockets (female), converted into unbalanced audio signals, and output from ⑤ ⑩ "AUX" knob ⑦ "HEADPHONES ROUTE" switch Adjusts the volume of external input audio signal from ⑫ "AUX" input jack.
5. SIGNALFLOW & ROUTING Input To Modular 1 OUT 1 INPUT MIX OUT 2 2 Level Stereo Aux Input IN I M O AUX Attenuator Headphones LED OVERLOAD PROTECTION Route LED I M O Route OUT Volume OUT Output From Modular IN 1 1 OUTPUT MIX IN 2 2 Level FIG.
6.
