Instruction manual

13
9. Quick Reference
Function
input
Operation Function
Main Sub
[Keypad 1-255]+[CAM] Select camera
ž ž
Power supply ON + [SET] First stage controller setting
ž ž
[SET]
[SET]+[J.S Stop]+[Keypad 1-64]+[PST]
[Preset No]+[PST]
[CLR+3sec.]+[Keypad 1-64]+[PST]+[ENT]
[CLR+3sec]+[PST]+[ENT]
Start set mode
Input and set the preset point
Move to preset point
Partial deletion of preset
Whole deletion of preset
ž ž
[SET]+[SlWING]
[1/2]+[ENT]
[Keypad 1-64]+ [ENT]+[Keypad 1-64]+
[ENT]
[Keypad 1-127]+[ENT]
[Keypad 1-64]+[ENT]
[1I2]+[SWING]
[SWING]/Joystick
Start set swing mode
Select of pan or tilt swing
Set up of two preset point
Set up of swing speed
Set up of stop time
Start pan or tilt swing
Stop swing
ž ž
[SET]+[GROUP]
[Keypad 1-6]+[ENT]
[Keypad 1-64]+[ENT]
[Keypad 1-64]+[ENT]
[Keypad 1-127]+[ENT]
[SET]
[Keypad 1-6]+[GROUP]
[GROUP]/Joystick
Start set group mode
Select of group number
Select of preset point
Set up the move speed of group
between presets
Set up the dwell time of group
Complete setting of group
Start group surveiliance
Stop group surveillance
ž ž
[SET]+[TOUR]
[Keypad 1-6]+[ENT] repeat
[SET]
[TOUR]
[TOUR]/Joystick
Start set tour mode
Set up tour
Ending of setting up Tour
Start tour surveillance
Stop tour surveillance
ž ž
[MENU]
[1]+[MENU]
[F/F]/Joystick
[F/N]
Start menu mode
Mark of OSD Menu
OSD Menu enter
OSD Menu escape
ž ž
Function
input
Operation Function
Main Sub
[2]+[MENU]+[ON/OFF] Set motion detect ON or OFF
ž
[3]+[MENU]+[ON/OFF] Place of detection display ON/OFF
ž
[4]+[MENU]
Joystick
[Z/I,Z/O]/[F/F,F/N]
Mode of set up zone size displayed
Expansion of zone size (up/down,
right/left)
Reduction of Zone size (up/down,
right/left)
ž
[5]+[MENU]
(Keypad 1-10)+[ENT]
Motion sensitivity control mode
Motion sensitivity highest  10
Motion sensitivity lowest  1
ž
[6]+[MENU]
[keypad 1-64]+[ENT]
Motion preset set up mode
Motion preset set up
ž
[7]+[MENU]+[ON]
[7]+[MENU]+[OFF]
Spiral function practice
Spiral ending
ž
[8]+[MENU]t[ON]
[8]+[MENU]+[OFF]
P/T/Z Trace practice
P/T/Z Trace ending
ž
[9]+[MENU]+[ON]
[9]+[MENU]+[OFF]
P/ T/Z Trace memorising
Deleting memorised P/T/Z Trace
ž
[Keypad 1-255]+[CAM]+[10]+[MENU]+[ENT] Reset of chosen camera
ž ž
[20]+[MENU]
Joystick up/dow n +[CLR]
LCD brightness mode
Ending brightness control
ž ž
[STATUS]
[STATUS]
Freeze practice
Freeze discharge
ž ž
[1]+[STATUS] Confirmafion of MD set camera
ž
[ALARM]
[ALARM]
Go into alert mode
Out of alert mode
ž
ACI srl Farfisa Intercoms
Via E. Vanoni,3 - 60027 - OSIMO - AN - Italy
Tel. [phone] - Fax [phone]
Email: [e-mail]
http://www.acifarfisa.it