User's Manual

The Mayhem is a fully pneumatic paintball marker. It fires from

a closed bolt position. This means that the ball is loaded into the

breech, and is at rest before the trigger is pulled. Accuracy is

improved with this method. Unlike other markers the angle of

the drop tube can be changed from the left side to the right side

as well as center. This allows for playing different positions on

the field. Operation is as follows:

1. A CO2 or HPA source is connected to the

bottom line.

2. The pressure regulator reduces the

incoming gas pressure to approxi-

mately 100 PSI.

3. The air flow is administered to

the gun body through the rear

base connection. Gas flows

through the spool valve and

the poppet into the main cham-

ber pushing the bolt closed, and

loading a ball into the breech.

4. When the trigger is pulled the poppet

moves to the rear allowing the gas trapped

in the main chamber to escape through the bolt

propelling the ball out of the barrel

5. When the pressure in the main chamber is reduced to 0 PSI

the main spring pushes the bolt open allowing the next ball

to fall into the breech.

6. When the trigger is released the process is reset.

Note: Breeches to fit all barrel threads are available. There are

three main parts to the marker body, they can all be inter-

changed with different colors to customize the

marker. Drop Tubes are screwed in and

can also be interchanged.

Caution: The Ball Detent in this

marker uses a small spring that is

under tension. When sliding

the cylinder off of the breech,

the spring will pop out and

can be easily lost, take care to

prevent this from occurring as

the spring is small and difficult

to see!

Description of Markers Operation