User's Manual

removing the two sets of knurled service screws
as shown in Figures 5 and 6. NOTE: DO NOT
USE TOOLS,THEY ARE NOT NECESSARY.
After barrel and field strip screws have been
removed, marking pistol can then be “broken
down” to its prim components for cleaning as
shown in figure 7. NOTE: DO NOT USE
TOOLS OR ATTEMPT TO DISASSEMBLE THE
MARKER BEYOND THIS POINT.
Refer all further service or repair to qualified
factory personnel only.
Before reassembling, lightly treat internal com-
ponents with airlube. Reassemble your marker
following figure 7 on the next page.
DO NOT USE TOOLS. Both sets of field strip screws
should be finger tight only. DO NOT FORCE.
For best accuracy always keep inside of barrel
clean and dry. use squeegee or swab for best
results.
WARNING: Any attempted modification or
service or other tampering by the owner or any
other person may cause the marker to mal-
function and may render it unsafe. Any repairs
should be made only by qualified factory per-
sonnel. For information on use and service,
please write: ACI Sports 701 Auto Center
Drive, Ontario CA 91761 USA.
Figure 5
Figure 6
RECOMMENDED AMMUNITION
Use only water soluble .68 caliber marking
pellets available from most dealers and
distributors. For more information, contact
ACI Sports.