User's Manual
IMPORTANT
1. Firing velocity may vary according to altitude
and climate conditions.
2. Before using your paint pistol in play, yo must
al
ways first perform a “SAFE VELOCITY
TEST”. This can only be accomplished by
using a testing device called a “Velocity
Chronograph” and can be performed by the
dealership where you purchased this product
or at a local paintball playing field.
3. NOTE:This product is intended to be used at
a velocity no gr
eater than 320 feet per sec-
ond (FPS). Recommended velocity is 300 FPS
or less.
4. This product is not intended to be used at
any distance less than 25 feet.
5. lower velocities may be attained by substitut-
ing a lighter hammer spring, (Item #34), avail-
able through your dealer or distributor.
▲
!
WARNING ▲
!
When removing piston form storage, or when handing
to, or receiving from another person, always check
to be sure the pistol is not loaded.
OPERATING INSTRUCTIONS
1. CO2 Charging
Your paint pistol has been equipped with an air
adapter for bulk CO
2 Screw, CO2 tank or
accessory into rear adapter of paint pistol as
shown (See Figure 1).
Use only 12 gram type CO
2 cartridges which
are flat on the small end. Any other cartridge
form or shape, such as those having threads on
on end, will not function and should not be
used.
CO
2 guns should not be used in temperatures
below 40˚ fahrenheit as performance decreases
significantly below this level. CO2 cartridges
may explode at temperatures above 160˚ F.
Figure 1










