User's Manual

Loading
Install a 7/8 elbow and loader on the ball feed tube. Following the direc-
tions of the manufacturer, fill the loader with .68 caliber paintballs.
Trigger Safety
The F4 has a trigger safety to help prevent accidental firing. With
the F4 pointing away from you, engage the safety by pushing it to
the right. When the safety is toward the left the F4 can then be
fired. The safety may not engage unless the F4 is cocked.
Remember, the only time the F4 is truly safe is when it is
unloaded and depressurized
Firing
To fire the F4, point it in a safe direction, away from yourself, and
pull the trigger. The trigger safety must be off; that is to the left.
Fire the F4 as often as you like with air, with or without paintballs
in it. This helps break it in and makes it operate smoother.
Uncocking
Before uncocking, unload. Rotate your gun to the side so paint-
balls in the chamber and elbow roll back into the loader. Take a
couple of shots in a safe direction to insure that the barrel is
empty. If you uncock with a ball in the chamber, it will be forced
forward into the barrel. Later when you recock, a second ball will
enter the chamber. If two balls are fired at once, they may break.
To finish uncocking, unscrew the air source, pull back the cocking
knob, pull the trigger and let the assembly move forward slowly.
DO NOT DRY FIRE THE F4. (To pull the trigger, the safety
must be disengaged.)
Air Source Removal
Once the F4 is properly uncocked with the safety on you can
depressurize it. To depressurize the F4, slowly unscrew the air
source paying special attention to the bottle valve. DO NOT
UNSCREW THE BOTTLE VALVE FROM THE BOTTLE.
UNSCREWING THE VALVE COULD CAUSE SERIOUS
INJURY OR DEATH.
WARNING
Avoid dry firing (without air) — damage to the
valve body, stop pin, and cup seal can occur.