User's Manual

CLEANING SCHEDULE
Every 500-1000 shots • Lubricate with AIRLUBE™
Every 1-3,000 shots • Remove bolt
• Clean upper chamber and bolt
• Check bolt O-rings
• Lubricate trigger assembly
7500-25,000 shots • Remove striker
• Clean striker and lower chamber
• Check striker O-ring for wear
Storage • Unpressurize and Unload
• Clean and Dry
• Lube
In the event of a ball break within the gun, the Field Strip proce-
dure on page 7.
This schedule may need to be revised depending on the playing
conditions.
Lubrication
Lubrication affects recocking and velocity. AIRLUBE™ (provid-
ed) works well at all temperatures.
DO NOT USE FIREARM LUBRICANTS. THEY CAN GET
STICKY WHEN CHILLED BY CO2 OR COLD WEATHER.
SERVICE HINTS
Bolt Pin and Velocity Adjustment Screw
Nylon pins in these areas prevent movement when the gun is
fired. If the connecting pin or velocity adjustment screw is loose,
replace the nylon pins (supplied) by pressing them out.
Coc
king Assembly Pin
It is tool steel, and must be kept oiled or it will rust.
O-rings
The valve body O-rings will last for years if not disturbed.
Improper O-rings can interfere with recocking or cause air leak-
age. Keep the O-rings on the bolt and striker clean; grit and dust
abrade them rapidly.
T
rigger Assembly
Keep the assembly clean and the metal parts oiled to prevent rust.
There are no user-serviceable parts inside the trigger assembly.
Valve Body
To extend valve body life, DO NOT REMOVE IT! There is a
safety stop pin pressed into the main body to prevent the valve
body from moving backwards. If the valve body must be
removed, it should be pushed out the front of the gun with a long
nylon rod or equivalent to prevent damage to the inside of the
valve chamber. Make a note of orientation before removal of the
valve body to ensure proper assembly. Properly lube and inspect
O-rings before reinstalling valve body.
(Refer to diagram on Pg 14)