User`s guide

BIOS Utility 2-7
2.2.9 IDE Secondary Channel Master
This parameter specifies the current configuration of the IDE device
connected to the master port of the secondary IDE channel. For
information on how to configure the IDE devices, see section 2.4.3.
2.2.10 IDE Secondary Channel Slave
This parameter specifies the current configuration of the IDE device
connected to the slave port of the secondary IDE channel. For
information on how to configure the IDE devices, see section 2.4.3.
2.2.11 Total Memory
This parameter specifies the total amount of onboard memory. The
memory size is automatically detected by BIOS during the POST
(Power-On Self Test). If you install additional memory, the system
automatically adjusts this parameter to display the new memory size.
1st Bank
This parameter indicates the type of DRAM installed in the DIMM 1
socket. The
None
setting indicates that there is no DRAM installed.
For the location of the DIMM sockets, refer to Figure 1-2.
2nd Bank
This parameter indicates the type of DRAM installed in the DIMM 2
socket. The
None
setting indicates that there is no DRAM installed.
For the location of the DIMM sockets, refer to Figure 1-2.
2.2.12 Serial Port
This parameter shows the serial port address and IRQ settings.