User Manual

9
English
Installation
To install the monitor on your host system, please follow the steps below:
Steps
1 Connect the video cable
a Make sure both the monitor and computer are switched off.
(1) Make sure both the monitor and computer are switched off.
(2) Connect one end of the 24-pin DVI cable to the back of the
2 Connect the power cord
Connect the power cord to the monitor, then to a properly grounded AC
outlet.
Turn on the monitor and computer
Turn on the monitor first, then the computer. This sequence is very
important.
If the monitor does not function properly, please refer to the
troubleshooting section to diagnose the problem.
monitor and the other end to the computer's port.
Connect the digital cable (only for DP models).
(1) Make sure both the monitor and computer are switched off.
(2) Connect one end of the 20-pin DP cable cable to the back of the
monitor and the other end to the computer's port.
Optional:Connect the audio input socket(AUDIO IN) of the LCD monitor
and the line-out port on the computer with the audio cable.
3
4
5
HDMI Cable (Only HDMI or MHL Input Model)
a. Make sure both the monitor and computer are powered-OFF.
b. Connect the HDMI or MHL cable to the computer.
b Connect the digital cable (only for dual-input models).
c
d
2
FreeSync (DP only):
It can allow a FreeSync supported graphics source to dynamically adjust
display refresh rate based on typical content frame rates for power
efficient, virtually stutter free and low-latency display update.
------------------------------------------------------------------------------------------------------------------------------------------
Note: Audio output is only for audio output model. Please check user manual for more instruction.