user manual
Table Of Contents
- TravelMate 2000/2500
- Revision History
- Copyright
- Conventions
- Preface
- Table of Contents
- Ch.1 System Introduction
- Ch.2 System Utilities
- Ch.3 Machine Disassembly and Replacement
- General Information
- Disassembly Procedure Flowchart
- Removing the Battery
- Removing the Memory Module
- Removing the Wireless LAN Board and the Modem Board
- Removing the Hard Disk Drive Module
- Removing the LCD Module
- Disassembling the LCD Module
- Disassembling the Main Unit
- Removing the Keyboard
- Removing the RTC Battery
- Removing the Fan
- Removing the Thermal Module
- Removing the Processor
- Installing the Processor
- Removing the Upper Case Assemly
- Removing the Touchpad Board
- Removing the Touchpad Cable
- Removing the VGA Thermal Plate
- Removing the CPU Heatsink Plate
- Removing the Second Fan Bracket
- Removing the ODD Module(1)
- Removing the ODD Module(2)
- Removing the HDD Bracket
- Removing the Main Board
- Removing the DC Board
- Removing the I/O Port Bracket
- Removing the PCMCIA Slot
- Removing the Speaker Set
- System Upgrade Procedure
- Ch.4 Troubleshooting
- Ch.5 Jumper and Connector Locations
- Ch.6 FRU (Field Replaceable Unit) List
- App.A Model Definition and Configuration
- App.B Test Compatible Components
- App.C Online Support Information
Chapter 4 82
Error Message List
No beep Error Messages FRU/Action in Sequence
No beep, power-on indicator turns off and LCD is
blank.
Power source (battery pack and power adapter). See “Power
System Check” on page 76.
Ensure every connector is connected tightly and correctly.
Reconnect the DIMM.
LED board.
System board.
No beep, power-on indicator turns on and LCD is
blank.
Power source (battery pack and power adapter). See “Power
System Check” on page 76.
Reconnect the LCD connector
Hard disk drive
LCD inverter ID
LCD cable
LCD Inverter
LCD
System board
No beep, power-on indicator turns on and LCD is
blank. But you can see POST on an external
CRT.
Reconnect the LCD connectors.
LCD inverter ID
LCD cable
LCD inverter
LCD
System board
No beep, power-on indicator turns on and a
blinking cursor shown on LCD during POST.
Ensure every connector is connected tightly and correctly.
System board
No beep during POST but system runs correctly. Speaker
System board