PCI to Ultra SCSI RAID Controllers Installation Guide
Table Of Contents
- Outside Front Cover
- Inside Front Cover
- Greetings/Please Notice/Our Policy
- About This Manual
- TABLE OF CONTENTS
- Chapter 1: Introduction
- Chapter 2: Preinstallation Planning
- Chapter 3: Installation
- Chapter 4: Controller Start-up
- Appendix A: Battery Backup Unit Option
- Appendix B: DAC960PG and DAC960PJ Specifications
- Appendix C: Error Messages
- Appendix D: Enclosure Management
- Appendix E: Regulatory Information
- Glossary
General Hardware Specifications
B-2 DAC960PG and DAC960PJ Installation
DAC960PJ
Controller DAC960PJ
CPU Intel i960 RD® RISC 32-bit microprocessor, 66MHz
Memory EDO ECC RAM, 60ns, 72-pin SIMM, n x 40
(Use only Mylex supplied SIMMS)
Minimum: 4 MB
Optional: 8, 16, 32, 64, or 128 MB
Cache Write: Selectable – Write/Through or Write/Back
Error Protection: Error Correction Code (ECC)
Firmware ROM Type, Flash EEPROM, 512K x 8
PCI I/O Processor: Embedded Intel i960 RD
32-bit bus
Transfer Rate: Up to 133MB/second
SCSI Mylex BA-81C15, one per channel
Data Rate: Up to 40 MB/second when using
Fast/Wide 16-bit mode