User's Guide

Acer p700 Series Portable Navigator setup
viii
Acer p700 Series Portable Navigator setup
Using your new Acer p700 Series Portable Navigator for the first time is a snap.
Unpack, turn on, mount and you’re ready to go. Perform the following easy
installation tasks to start using the device straight out of the box:
1. Unpack the device.
2. Set up the device in your vehicle.
NOTE: You should not use the power switch again unless you want to do a hard reset. See
"Performing a hard reset" on page 54 for more information. Instead, use the power button
at the top of the device (see diagram below).