User Manual

Machine Maintenance 3-5
Machine Maintenance
This chapter contains step-by-step procedures on how to disassemble the notebook
computer for maintenance and troubleshooting.
Machine Disassembly and Replacement 0
Cable paths and positioning may not represent the actual model. During the removal and
installation of the components, ensure all available cable channels and clips are used and
that the cables are replaced in the same position.
The screws for the different components vary in size. During the disassembly process, group
the screws with the corresponding components to avoid mismatch when putting back the
components.
The product previews seen in the disassembly procedures may not represent the final
product color or configuration.
Recommended Equipment 0
To disassemble the computer, the following tools are suggested:
Wrist grounding strap and conductive mat for preventing electrostatic discharge
Non-marring scribe
Phillips screwdriver
Flat-blade screwdriver
Plastic flat screwdriver
Plastic tweezers
Cyanoacrylate glue
Replacement Requirements 0
NOTE:
NOTE:
Cabling and components require adhesive to be applied during the replacement and
reassembly process.
NOTE:
NOTE:
When replacing individual component, the system should be reset to the factory default
condition by removing and replacing the RTC battery. Please refer to the procedures
described on pages 3-15 and 3-79.