User Manual

2-20 System Utilities
8. Key in the generated supervisor password in below window to unlock the system.
Figure 2-22. Generated Supervisor Password
9. Perform the “Removing a Password” procedure described on page 2-11 using the
generated supervisor password to clear the password.
Windows Mode 0
To reset the BIOS password under Windows environment:
1. Open DOS Command Prompt.
2. Type the following command:
C\> unlockpw.exe XXXXXXXX
Figure 2-23. BIOS Supervisor Password
3. Write down the generated supervisor password.
4. Reboot the computer. During POST, press
F2.
5. Select
Enter Unlock Password.
Figure 2-24. Password Error Status
6. Key in the generated supervisor password to unlock the system.
Figure 2-25. Password Unlock Code
7. Reboot the computer and press F2 during POST to enter BIOS Setup Utility.
8. Key in the generated supervisor password in below window to unlock the system.
Figure 2-26. Generated Supervisor Password
9. Perform the “Removing a Password” procedure described on page 2-11 using the