User Manual

System Utilities 2-13
Boot 0
Use this tab to set the preferred drive sequence in which the Setup Utility attempts to boot the
operating system. By default, the computer searches for boot devices in the following order:
1. Windows Boot Manager
2. Primary Hard Disk Drive
3. Optical disc drive
4. External USB bootable device
5. Network boot - IPV4
6. External USB hard drive
7. External USB optical drive
8. Network boot - IPV6
Press to select a device and press F5 or F6 to move it up or down the list.
Figure 2-9. BIOS Boot
Table 2-9. BIOS Boot
Parameter Description Option
Secure Boot Option to enable or disable secure boot check.
Note: Configure this option only if Boot Mode
is set to UEFI.
Enabled or Disabled
Boot Priority Order Option to change the order of drives from
which your computer will try to start up.
–
Item Specific Help
Use < > or < > to select
a d e v i c e , t h e n p r e s s < F 6 >
t o m o v e i t u p t h e l i s t , o r
< F 5 > t o m o v e i t d o w n t h e
list. Pres <Esc> to escape
the menu.
F1
Esc
Help
Exit
Select Item
Select Menu
Change Values
Select Sub-Menu
F5/F6
Enter
F9
F10
Setup Defaults
S a v e a n d E x i t
MainInformation
InsydeH20 Setup Utility
Security Boot ExitAdvanced
Secure Boot:
Boot priority order:
1: Windows Boot Manager
[Enabled]