User Manual

4-4 Troubleshooting
Power On Issues 0
If the system does not power on, perform the following, one at a time, to correct the problem.
Do not replace a non-defective FRU.
Figure 4-1. Power On Issue
Computer Shuts Down Intermittently 0
If the system powers off at intervals, perform the following.
1. Makes sure the power cable is properly connected to the computer and the electrical
outlet.
2. Remove all extension cables between the computer and the outlet.
3. Remove all surge protectors between the computer and the electrical outlet. Plug the
computer directly into a known serviceable electrical outlet.
4. Disconnect the power and open the casing to check the thermal module and fan airways
are free of obstructions. Refer to the to the “Thermal Unit Failure” section on page 4-17.
5. Remove all external and non-essential hardware connected to the computer that are not
necessary to boot the computer to the failure point.
6. Remove any recently installed software.
7. If the issue is still not resolved, refer to the Online Support Information on page 8-3.
Start
Check AC/Battery
Power on
Check
power/card reader
board/cable
connection
Replace Mainboard
Swap AC/Battery
OK
NG
Replace power/card reader board
Reconnect power/card reader
board cable
OK
NG