User Manual
Table Of Contents
- Predator Triton 515-51 Service Guide V1.00
- CHAPTER 1 - Hardware Specifications
- CHAPTER 2 - System Utilities
- CHAPTER 3 - Machine Maintenance
- Machine Maintenance
- Machine Disassembly and Replacement
- Disassembly Process
- Main Unit Disassembly Process
- Main Unit Disassembly Flowchart
- Removing the Lower Case
- Removing the Battery Pack
- Removing the WLAN Module
- Removing the RTC Battery
- Removing the DC-In Cable
- Removing the Mainboard
- Removing the Touchpad Module
- Removing the Left and Right Speakers
- Removing the WLAN Antenna
- Removing the Turbo Key Module
- Removing the Memory Modules
- Removing the SSD Modules
- Removing the Thermal Module
- Removing the Upper Case
- LCD Module Disassembly Process
- LCD Module Reassembly Process
- Main Unit Reassembly Process
- Replacing the Upper Case
- Replacing the Thermal Module
- Replacing the SSD Modules
- Replacing the Memory Module
- Replacing the Turbo Key Module
- Replacing the WLAN Antenna
- Replacing the Left and Right Speakers
- Replacing the Touchpad Module
- Replacing the Mainboard
- Replacing the DC-In Cable
- Replacing the RTC Battery
- Replacing the WLAN Module
- Replacing the Battery Pack
- Replacing the Lower Case
- Machine Maintenance
- CHAPTER 4 - Troubleshooting
- CHAPTER 5 - Jumper and Connector Locations
- CHAPTER 6 - FRU List
- CHAPTER 7 - Test Compatible Components
- CHAPTER 8 - Online Support Information
Machine Maintenance 3-53
5. Place the double sided adhesive tapes into the LCD panel cover as shown and press
them down until they stick into place.
NOTE:
NOTE:
Make sure that the non-stick pull tab is located at the top of the LCD panel cover.
Figure 3-73. LCD Panel - Double Sided Adhesive Tapes
6. Align and install the four mylar gaskets to the top of the panel frame on the LCD panel
cover, as shown. Note that the gasket tabs should be facing upwards.
Figure 3-74. Mylar Gaskets