Operation Manual
Table Of Contents
- About this Manual
- First things first
- 1 Getting started
- 2 Entering data in your Acer n35
- 3 Managing applications and information
- 4 Managing Microsoft® Pocket Outlook applications
- 5 Managing Microsoft® Pocket PC 2003 SE companion programs
- 6 Backup and restore data
- 7 Using expansion features
- 8 Exchanging and updating data using ActiveSync®.
- 9 Getting connected
- 10 Using Microsoft® Pocket Internet Explorer
- 11 Customising your handheld
- Appendix A: Regulation & safety notices
- FCC notice
- Notice: Shielded cables
- Notice: Peripheral devices
- Caution
- Operation conditions
- Notice: Canadian users
- Remarque à l’intention des utilisateurs canadiens
- Declaration of Conformity for EU countries
- Important safety instructions
- LCD pixel statement
- Radio device regulatory notice
- General
- European Union (EU)
- List of applicable countries
- The FCC RF safety requirement
- Canada - Low-power license-exempt radio communication devices (RSS-210)
- Exposure of humans to RF fields (RSS-102)
- Environmental Policy Declaration
First things first
Maintaining your Acer n35
vii
buttons or expansion slots. In general, treat your handheld as you would a pocket
calculator or other small electronic device.
3 Take care not to drop your handheld or subject it to any strong impact. Do not place
your handheld in your back pocket; if you sit on it, you may damage it.
4 Protect your handheld from temperature extremes. For example, do not leave your
handheld on the dashboard of a car on a hot day or on a day when temperatures are
below the freezing point. Also, keep it away from heaters and other sources of heat.
5 Do not use or store your handheld in any location that is extremely dusty, damp or
wet. Always use the (included) SD dummy card to protect the connectors when not in
use.
6 Use a soft, damp cloth to clean your handheld. If the surface of the screen becomes
soiled, clean it with a soft cloth moistened with diluted window-cleaning solution.
Resetting your Acer n35
You may have to perform a reset if your handheld no longer responds to the buttons
on the screen.
Performing a soft reset
A soft reset allows your handheld to get a fresh start, similar to rebooting a computer.
All records and entries are retained after a soft reset.
To perform a soft reset:
• Using the tip of your stylus, lightly press the reset button inside the hole on
the buttom of your handheld.
Performing a hard reset
A hard reset will erase all records and entries stored in your handheld. Never perform
a hard reset unless a soft reset does not correct your problem. When you perform your
next ActiveSync operation, you can restore any data that you previously synchronised
to your computer. To perform a hard reset: