Operation Manual
Table Of Contents
- About this Manual
- First things first
- 1 Getting started
- 2 Entering data in your Acer n35
- 3 Managing applications and information
- 4 Managing Microsoft® Pocket Outlook applications
- 5 Managing Microsoft® Pocket PC 2003 SE companion programs
- 6 Backup and restore data
- 7 Using expansion features
- 8 Exchanging and updating data using ActiveSync®.
- 9 Getting connected
- 10 Using Microsoft® Pocket Internet Explorer
- 11 Customising your handheld
- Appendix A: Regulation & safety notices
- FCC notice
- Notice: Shielded cables
- Notice: Peripheral devices
- Caution
- Operation conditions
- Notice: Canadian users
- Remarque à l’intention des utilisateurs canadiens
- Declaration of Conformity for EU countries
- Important safety instructions
- LCD pixel statement
- Radio device regulatory notice
- General
- European Union (EU)
- List of applicable countries
- The FCC RF safety requirement
- Canada - Low-power license-exempt radio communication devices (RSS-210)
- Exposure of humans to RF fields (RSS-102)
- Environmental Policy Declaration
1 Getting started
Preparing to use your Acer n35
11
Plug the USB sync cable into the 26-pin I/O connector on the bottom of your handheld
and plug the USB client connector into an available USB port on your computer
.
Charging your Acer n35
For initial use, you need to charge your handheld for three hours. After that, you can
charge it for a few minutes each day to recharge the battery to full capacity. Normally,
you can use your handheld for 8 straight hours of operation (backlight inactive)
before you need to recharge the battery.
To charge your Acer n35
Connect the AC adapter connector to the handheld, then plug the other end of the
AC adapter into any AC outlet.